San Mateo · Residential Dryer Exhaust Cleaning Inspection
Dryer Exhaust Cleaning & Inspection in San Mateo, CA
A San Mateo home had its dryer exhaust deep cleaned after heavy lint buildup was found packed along the duct connection, with a new UL 2158A transition duct installed to restore safe, full airflow.
Completed November 12, 2026

The dryer connection point and transition duct, before and after. The new 4 foot DryerFlex Transition Duct with two DryerClamps is now installed and properly secured, clearing the path for full airflow.
What We Found
During this residential dryer exhaust cleaning and inspection in San Mateo, our technician pulled the dryer away from the wall and immediately found heavy lint accumulation packed along the duct transition at the back of the unit. The flexible duct connecting the dryer to the wall stub-out was matted with compacted lint on its exterior, lint had collected on the floor behind the appliance, and the lint trap itself was loaded with a dense gray mat across the full width of the mesh screen. At the exterior-side periscope vent fitting inside the dryerbox recess, a visible clump of lint was trailing out of the crimped outlet edge, confirming the blockage extended through the connection point and not just at the appliance. This level of buildup is consistent with severe lint accumulation, a condition the U.S. Fire Administration identifies as the leading factor behind the roughly 15,000 home dryer fires reported each year, and it typically restricts airflow well below the 200 CFM threshold a dryer needs to operate efficiently and safely.
What We Did
The technician removed the dryer's back panel to gain full access to the rear connection point, then worked the entire exhaust path with a drill-attachment rotary brush paired with a high-powered shop vac, clearing lint from the dryer connection through to the exterior cap. This included brushing out the rigid metal wall stub-out and the periscope vent fitting in the dryerbox niche, where the worst of the compacted material had accumulated. Because the existing transition hose was crushed, dusty, and no longer suitable for a sealed, code-compliant connection, it was replaced with a new 4 foot DryerFlex transition duct, listed to UL 2158A, secured at both ends with two DryerClamps per IRC M1502.4.3's requirement that transition ducts be listed, labeled, and properly fastened. The new duct was routed in a clean, unkinked path from the dryer outlet to the rigid metal duct stub, with the foil-taped collar left intact and the gas supply line and electrical connections undisturbed throughout the work.
The Outcome
After the cleaning pass and transition duct replacement, the connection area, wall opening, and dryerbox niche were all confirmed clear of lint and debris, with the rigid metal stub-out and periscope fitting visibly open and unobstructed. The new transition duct runs in a clean, properly supported path without crushing or kinks, restoring the full cross-section needed for proper exhaust flow. Homeowners in San Mateo with similar setups should know that a fully loaded lint trap and a crushed or non-UL 2158A transition hose are two of the most common contributors to restricted airflow and extended drying times, and both were addressed directly in this visit. With the duct cleared end to end and a properly listed transition duct now in place, the system is positioned to exhaust efficiently and reduce the fire risk associated with trapped lint.
Maintenance Recommendation
Given the severity of the lint accumulation found at this property, we recommend scheduling a follow-up cleaning sooner than the typical annual interval, particularly if drying times start to lengthen again or the dryer runs noticeably hotter to the touch. Routine annual cleaning, paired with periodic checks that the transition duct remains unkinked and properly clamped, is the simplest way to keep the exhaust path operating at full capacity and to catch buildup before it reaches the level found during this visit.
Project photos
11 photos










Need similar work in San Mateo?
Get a free quote - same-week appointments usually available.
